Set Up Instructions

Eliminator Single Room Heater Package

BASIC ONE HEATER PACKAGE SET UP:

1. Prepare room by: Covering A/C Vents & Clearing all Heat Sensitive Items from the room.

2. Place EcoForce Eliminator and two fans into the infested room. Note: Make sure there are no obstructions in front of, or behind the heater. 

3. Plug heater power cord (Black Cord) and fan(s) power cord into the room’s wall outlets.

4. Plug the 4 blue extension cords into the heater element ports located on the sides of the  heater (2 per side).

one_heater_package

5. Route blue cords under the room door and plug into 4 separate 20 amp breakers.

6. Turn all the equipment on. Make sure all the 5 lights on the Eliminator heater are illuminated. 

7. Use a handheld temperature monitor to take temperatures around the room throughout treatment.  

Fluke_62_MAX__62_MAX__Infrared_Thermometers

8. Reach a target range of 120°F-140°F. Keep temperature at target for a minimum of 4 hours.

Note: Keep the air inlet & outlet clear of any obstructions and loose material. Machine will shut itself off as a safety mechanism if either end is blocked. 

Eliminator Single Room Heater Package w/ Distribution Unit

ELIMINATOR  W/ DISTRIBUTION BOX SET UP:

1. Prepare room by: Covering A/C Vents & Clearing all Heat Sensitive Items from the room.

2. Place EcoForce Eliminator and two fans into the infested room. Note: Make sure there are no obstructions in front of, or behind the heater. 

3. Plug heater power cord (Black Cord) and fan(s) power cord into the room’s wall outlets.

4. Connect 220V Industrial Cord into GMS Distribution Box, Twist and Lock.   Untitled__Eliminator_with_Distribution_Unit_copy_5. Plug the Black Industrial Cord into either the range or dryer (depending on the electrical source used). Ensure all breakers on the box are switched to the ON position.

6. Place distribution box OUTSIDE of the room to be treated. Plug 4 Blue Extension Cords into the Red outlets on the GMS Box. IMPORTANT! One cord per outlet.Eliminator_with_Distribution_Unit_pages4. Plug the female end of the 4 Blue Extension Cords into the Eliminator Heater (2 per side). Make sure the heater’s Black Power Cord is plugged into a room outlet to power the unit.    Eliminator_with_Distribution_Unit_pages_15. Turn Heater and heating element switches to the ON position. All 5 lights should be illuminated.

6. Position fans in the room to direct the heat in the desired direction. Turn Fans on. Fans can be moved to heat other areas throughout the treatment process. 

7.  Close the door to the room with extension cords running underneath the bottom of the door. Seal the room by placing a towel, blanket, or similar item under the door. This helps the room reach target temperatures quicker.

8. Reach a target range of 120°F-140°F. Keep temperature at target for a minimum of 4 hours.

Note: Keep the air inlet & outlet clear of any obstructions and loose material. Machine will shut itself off as a safety mechanism if either end is blocked.